Step By Step Instructions on How To Replace a HotPoint Dryer Belt

Step By Step Instructions on How To Replace a HotPoint Dryer Belt

🛠️ How to Replace a Broken Hotpoint Dryer Belt

Meta Description:
Is your Hotpoint dryer drum not spinning? Learn how to replace a broken dryer belt with this clear DIY guide. Save money and get your dryer running again fast! 

If you are the type that loves to learn while watching instead of reading, you can skip the blog and just watch this video below. 

🧯 Is Your Hotpoint Dryer Not Spinning?

It’s frustrating when your dryer suddenly stops working — especially if the drum isn’t spinning. Before you call a repair tech or start shopping for a new dryer, check the belt. In many cases, a broken or worn-out belt is all that’s standing between you and a functioning machine.

The best part? You can fix it yourself in under an hour with just a few tools and a new belt.

🔧 What You’ll Need

  • ✅ Replacement belt (check your model, common one is Hotpoint WE12M29)
  • ✅ Phillips screwdriver
  • ✅ Socket wrench or nut driver
  • ✅ Putty knife
  • ✅ Vacuum or cleaning brush (optional)
  • ✅ Work gloves (recommended)

⚠️ Safety First

Always unplug your dryer before starting this repair.
If you have a gas dryer, be sure to turn off the gas supply as well.

👨🔧 Step-by-Step Instructions to Replace a Hotpoint Dryer Belt

Step 1: Remove the Lint Filter and Top Panel

  • Open the dryer door and take out the lint filter.
  • Remove the screws under the lint filter housing.
  • Use a putty knife to release the clips holding the top panel.
  • Carefully lift the top panel and prop it open.

Step 2: Remove the Front Panel

  • Locate and unscrew the front panel screws (usually near the top corners).
  • Tilt the panel forward and disconnect the door switch wire harness.
  • Set the panel aside safely.

Step 3: Release and Remove the Drum

  • Look under the drum to find the tension pulley.
  • Slide the belt off the motor shaft and pulley.
  • Carefully lift out the drum.

Step 4: Install the New Belt

  • Wrap the new belt around the drum (ribbed side down).
  • Place the drum back into the cabinet.
  • Re-thread the belt through the tension pulley and motor shaft (follow your dryer’s diagram or the video above for correct routing).

Step 5: Reassemble the Dryer

  • Reconnect the door switch and screw the front panel back on.
  • Lower the top panel and snap it into place.
  • Reinstall the lint filter and its screws.
  • Plug in the dryer (or turn the gas back on).

🌀 Bonus Tip: Clean Out the Lint

While the dryer is open, vacuum out any lint around the motor and base. A clean dryer not only works better — it’s safer too.

✅ Final Test

Run a short cycle. If the drum spins and there’s no unusual noise, congratulations — your Hotpoint dryer is back in action!

💡 Final Thoughts

Replacing your dryer belt is a smart, money-saving repair that most people can handle with basic tools. The belt costs around $15–$30, and you’ve just saved at least $100 in service fees.

💬 Need help finding the right part for your Hotpoint model?
Drop a comment below or reach out — we’re happy to help!

📺 Video Credit:
How to Replace a Dryer Belt on Hotpoint - YouTube (My Appliance Fixed)

Back to blog

Leave a comment